Katedra technologií a měření / Department of Technologies and Measurement

Zobrazit statistiky


Poslední příspěvky

Kubíček, Robert
Vizualizace data IoT

The thesis contains a theoretical and a practical part. In the theoretical part, this work deals with an introduction to the concept of IoT and related technologies. In this part, the communication chain of the connected device is also analyzed, where the emphasis is on t...

Švagr, Kryštof
Stavba výukového modelu motoru

The work is in the first part focused on the propulsion systems used in electric cars, their cooling and the necessary electronics for operation. The next part deals with cars using to drive one of the mentioned systems. The last part is devoted to the main task,...

Přibek, Petr
Návrh pohonu elektrické koloběžky

The bachelor thesis presents design of synchronous motor with permanent magnets (PMSM) with outer rotor. The motor is designed for scooter rear wheel assembly. In the bachelor thesis, there is a calculation for electromagnetic design of the machine, spare parameters and machine losses.&...

Handrejch, Jan
Vícekanálové měření teploty pro platformu KETCube

The submitted bachelor thesis in its introductory part shortly deals with measured values (temperature, humidity), followed by a relatively extensive description of the used technologies, KETCube platform and an overview of available components for the design and proposal of expansion boards....

Kutěj, Petr
Görgesovo sedlo v momentové charakteristice synchronního motoru

The bachelor theses presents the Görgess saddle in torque characteristics of synchronous motor. This theses describes the begining of this phenomenon, simulating the start of the synchronous motor, where this phenomenon is and comparing the results with the teoretic one. The motor is&#x...