The use of asphaltic concrete cores for sealing embankments and rockfill dams is very important. The self-healing properties of bitumen, simple construction in cold and rainy conditions compared to clay cores, good flexibility and connection with embankment materials are the essential charac...

This paper presents a printed magnetic probe that can switch from broadband to tunable narrowband for near-field measurement. In the early design stage, we created a printed loop gap resonator as a magnetic reference sensor for the pre-compliance test in a band up to 6 GH...

This paper introduces a methodology to investigate controlled switching (or "Point on Wave Switching") to reduce magnetizing inrush current in Transformer. When transformer is switched on, transformer will get energized and transiently, large current flows through the primary winding. This&#...

We report the results of the measurements of three pieces of the new Photonis miniPLANACON microchannel-plate photomultipliers (MCP-PMTs) intended for use in the demanding environment of the Large Hadron Collider (LHC) beamline as a part of the AFP Time-of-Flight detector. These photomultipl...

This paper deals with the movement, localization and navigation possibilities of Autonomous Robotic Platform (ARP). Such a platform is used for ADAS (Advanced Driver Assistance Systems) testing in automotive. At the beginning, the paper discusses different solutions that are already available...

A search for exclusive two-photon production via photon exchange in proton-proton collisions, pp→pγγp with intact protons, is presented. The data correspond to an integrated luminosity of 9.4 fb−1 collected in 2016 using the CMS and TOTEM detectors at a center-of-mass energy of 13 ...

This article presents the design, modeling, and fabrication of a printed log-periodic biconical dipole array antenna (PLPBDA) for electromagnetic compatibility (EMC) measurements. The proposed structure used bow tie-shaped dipoles instead of typical dipoles to achieve a size reduction of 50% and&...

This article proposes a new branch-line coupler design using two trapezoid-shaped resonators, applied in side and center. The standard 35 and 50 Ohms λ/4 transmission lines (TLs) are attained through the variations of the resonator’s TLs width. Since there are not explicit formulas...

We describe an analysis comparing the p¯p elastic cross section as measured by the D0 Collaboration at a center-of-mass energy of 1.96 TeV to that in pp collisions as measured by the TOTEM Collaboration at 2.76, 7, 8, and 13 TeV using a model-independent approach. The...

Events where the two leading jets are separated by a pseudorapidity interval devoid of particle activity, known as jet-gap-jet events, are studied in proton-proton collisions at √s=13 TeV. The signature is expected from hard color-singlet exchange. Each of the highest transverse momentum...

Measurements are presented of the single-diffractive dijet cross section and the diffractive cross section as a function of the proton fractional momentum loss ξ and the four-momentum transfer squared t. Both processes p p → p X and p p → X p , i.e. with the pro...

The TOTEM collaboration at the CERN LHC has measured the differential cross-section of elastic proton–proton scattering at s√=8TeV in the squared four-momentum transfer range 0.2GeV2<|t|<1.9GeV2. This interval includes the structure with a diffractive minimum (“dip”) and a secondary maximum (“bu...

In the presented work, the parameters of a new MAPD-3NM-II photodiode with buried pixel structure manufactured in cooperation with Zecotek Company are investigated. The photon detection efficiency, gain, capacitance and gamma-ray detection performance of photodiodes are studied. The SPECTRIGMAPD is&#x...

The TOTEM experiment at the LHC has performed the first measurement at √s = 13 TeV of the ρ parameter, the real to imaginary ratio of the nuclear elastic scattering amplitude at t = 0, obtaining the following results: ρ = 0.09 ± 0.01 and ρ = 0.10 ± 0.0...

Oxide Precipitation-Hardened (OPH) alloys are a new generation of Oxide Dispersion- Strengthened (ODS) alloys recently developed by the authors. The mechanical properties of this group of alloys are significantly influenced by the chemical composition and appropriate heat treatment (HT). The main...

A new generation of Oxide Dispersion Strengthened (ODS) alloys called Oxide Precipitation Hardened (OPH) alloys, has recently been developed by the authors. The excellent mechanical properties can be improved by optimizing the chemical composition in combination with heat treatment. However, the&...

This paper presented a new detector module consisting of a micropixel avalanche photodiode (MAPD-3NM), LaBr3:Ce scintillator, and a compact read-out interface system for detecting gamma-rays in a wide energy range. The MAPD array (4 × 4 channels) was assembled using a singleMAPD-3NMcharacter...

This article investigates the design,modeling, and fabrication of small-size (150 x 90 x 1.6mm) broadband printed biconical antenna. The proposed antenna is intended for use a reference antenna for electromagnetic interference measurement inside the EMC chamber. The reflection coefficient (S11-paramet...

The response of a Timepix3 detector (256 x 256 pixels, pixel pitch 55 μm) with a 300 μm thick silicon sensor was studied in relativistic charged particle beams at the Super-Proton- Synchrotron at CERN. The detector was irradiated at different angles in a 400 GeV/𝑐 p...

The blood flow in human arterial system can be considered as a fluid dynamics problem. Simulation of blood flow will provide a better understanding of the physiology of human body. Simulation studies of blood flow in the diseased condition can help to diagnose the health ...